NewUserWalkthrough:Page03

New User Walkthrough - Page 3: Running Ogrebot for the first time

Running Ogrebot

Log into the game how you normally would (manually type in your username/password etc).
Once you are logged into the game:
- Open the console (the tilde key, ~)
- Type: Ogre
- Press <Enter>
More than likely there was a big window, that disappeared before you could really see what is going on. That is normal. Once Ogrebot loads, it automatically hides.

You will probably also have a Message box in the middle of your screen complaining about an Ogre Export.

An Export provides Ogrebot with information about your class abilities. An export goes through every single ability your character has, and determines what it is, and saves that information. This must be done on every single class you are going to use. If you ever obtain a new ability that you have never had before, you will also need to run a new export. Try to remember this, if you ever notice you have 1-2 abilities missing, it probably means it is time to run a new export.
Some times changes to Ogrebot will require you to run a new export also. This is generally very rare, but you'll get a pop up like this when it happens.
To get this export going, in the console:
- Type: ogre export
- Press <Enter>
You will see the export working away. This will take approximately 5 minutes. As it tells you, do not zone/camp while this is running. You can either take a 5 minute break, or continue on with this walkthrough. It will be noted later on in this walkthrough when you should check it.

Close the console (the tilde key, ~).
You should see a small little window with 3 options.
- Show Uplink
- Pause
- Show Main

This is the window that disappeared earlier.
You will notice a lot of options. For now, don't worry about them. Near the bottom left, click on the 'EQ2Chars' button.
- The next page of this walkthrough will walk through this page.

Continue to Page 4 EQ2Chars