Difference between revisions of "OgreMCP"

Revision as of 13:55, 24 February 2010

Tab Summary

Note: OgreMCP is currently named "Uplink". It will be renamed in the near future to "OgreMCP".

MCP = Master Control Panel. OgreMCP is used to pass commands via the uplink. To load the upload, type "Run ogre up" and a new window appears.

Note: Nearly all of these buttons are sending commands through the uplink, and will affect ALL sessions connected.

There are 4 "Tabs". Clicking each of these changes which buttons appear.
- General (default)
- Zones 1
- Other
- Other2
There are 6 static buttons. These never disappear, regardless of which "tab" you are on.
- Lets go - Defaulted on when the bot loads. This is used to remove the following flags: Hold up, No move, Do not move, Camp spot, Fiegn death. You can also use a chat command of "lets go" in a tell/group/raid to activate this command. -Queued command. Happens when the bot finishes what it is doing.
- Hold up - Turns OFF auto follow. -Forced command. This happens immediately, regardless if the bot is doing other things.
- Pause - Presses the "pause" button on the bot.
- Resume - Resumes the bot (counter to Pausing it).
- Uplink - New window (not yet released)
- Profile - Input box to allow you to load a new profile. Example: Grind would load a grind profile if it exists. If it doesn't exist, does nothing.

General Tab

User notes/comments/suggestions:

@@ Line 10: / Line 10: @@
 MCP = Master Control Panel. OgreMCP is used to pass commands via the uplink.
 To load the upload, type "Run ogre up" and a new window appears.
+Note: Nearly all of these buttons are sending commands through the uplink, and will affect ALL sessions connected.
 == Main Buttons (Left side)==
@@ Line 20: / Line 22: @@
 * There are 6 static buttons. These never disappear, regardless of which "tab" you are on.
 ** '''Lets go''' - Defaulted on when the bot loads. This is used to remove the following flags: Hold up, No move, Do not move, Camp spot, Fiegn death. You can also use a chat command of "lets go" in a tell/group/raid to activate this command. -Queued command. Happens when the bot finishes what it is doing.
-** '''Hold up'''
+** '''Hold up''' - Turns OFF auto follow. -Forced command. This happens immediately, regardless if the bot is doing other things.
+** '''Pause''' - Presses the "pause" button on the bot.
+** '''Resume''' - Resumes the bot (counter to Pausing it).
+** '''Uplink''' - New window (not yet released)
+** '''Profile''' - Input box to allow you to load a new profile. Example: Grind would load a grind profile if it exists. If it doesn't exist, does nothing.