Difference between revisions of "OgreMCP"
From ISXOgre
| Line 13: | Line 13: | ||
== Main Buttons (Left side)== | == Main Buttons (Left side)== | ||
| − | *There are 4 "Tabs". Clicking each of these changes which buttons appear. | + | * There are 4 "Tabs". Clicking each of these changes which buttons appear. |
** General (default) | ** General (default) | ||
** Zones 1 | ** Zones 1 | ||
** Other | ** Other | ||
** Other2 | ** Other2 | ||
| + | * There are 6 static buttons. These never disappear, regardless of which "tab" you are on. | ||
| + | ** '''Lets go''' - Defaulted on when the bot loads. This is used to remove the following flags: Hold up, No move, Do not move, Camp spot, Fiegn death. You can also use a chat command of "lets go" in a tell/group/raid to activate this command. -Queued command. Happens when the bot finishes what it is doing. | ||
| + | ** '''Hold up''' | ||
Revision as of 13:52, 24 February 2010
OgreMCP
Tab Summary
Note: OgreMCP is currently named "Uplink". It will be renamed in the near future to "OgreMCP".
MCP = Master Control Panel. OgreMCP is used to pass commands via the uplink. To load the upload, type "Run ogre up" and a new window appears.
Main Buttons (Left side)
- There are 4 "Tabs". Clicking each of these changes which buttons appear.
- General (default)
- Zones 1
- Other
- Other2
- There are 6 static buttons. These never disappear, regardless of which "tab" you are on.
- Lets go - Defaulted on when the bot loads. This is used to remove the following flags: Hold up, No move, Do not move, Camp spot, Fiegn death. You can also use a chat command of "lets go" in a tell/group/raid to activate this command. -Queued command. Happens when the bot finishes what it is doing.
- Hold up
General Tab
- ' - On/Off.
User notes/comments/suggestions:
