OgreMCP
From ISXOgre
Revision as of 13:52, 24 February 2010 by 216.121.180.9 (Talk)
OgreMCP
Tab Summary
Note: OgreMCP is currently named "Uplink". It will be renamed in the near future to "OgreMCP".
MCP = Master Control Panel. OgreMCP is used to pass commands via the uplink. To load the upload, type "Run ogre up" and a new window appears.
Main Buttons (Left side)
- There are 4 "Tabs". Clicking each of these changes which buttons appear.
- General (default)
- Zones 1
- Other
- Other2
- There are 6 static buttons. These never disappear, regardless of which "tab" you are on.
- Lets go - Defaulted on when the bot loads. This is used to remove the following flags: Hold up, No move, Do not move, Camp spot, Fiegn death. You can also use a chat command of "lets go" in a tell/group/raid to activate this command. -Queued command. Happens when the bot finishes what it is doing.
- Hold up
General Tab
- ' - On/Off.
User notes/comments/suggestions:
